Use the model library
Availability depends on your deployment. The upload and processing instructions below apply where those controls are enabled.
The model library appears in model creation and model editing. It combines bundled default models with uploaded assets belonging to your organization.
Browse and place a model
- Activate Place 3D Model.
- Browse the library. Sort by Name A-Z, Name Z-A, Newest first, or Oldest first.
- Use the page selector to browse additional entries.
- Select an available model and place it in the scene.
- Select the placement to adjust its properties.
Only ready uploaded assets can be selected for placement. Uploading a model does not automatically place it. When editing an existing model, selecting another library model changes the model used by that placement.
Use Refresh Library to retrieve library changes made elsewhere. Bundled models are read-only and cannot be edited or deleted through asset-management controls.
Upload an OBJ model
The current upload workflow accepts a single naked .obj file no larger than 5 MB. A naked OBJ contains geometry without a companion material or texture package. Uploaded geometry uses a neutral material.
- Open the model library.
- Under Upload OBJ Model, choose Choose OBJ File.
- Review the selected filename and size.
- Choose Upload.
- Monitor the upload and processing status.
- Once the asset is ready, select it separately to place it.
Use Cancel during an active upload if needed. If upload fails, read the explanation and use Retry Upload when available.
Understand processing status
| State | Meaning | What to do |
|---|---|---|
| Pending upload | The upload has not been accepted as complete. | Finish or recover the upload. |
| Uploaded | The source is accepted and waiting for processing. | Wait, or use Process if offered. |
| Processing | Processing is in progress. | Wait for the result. |
| Ready | The asset is available for placement. | Select it from the library. |
| Upload failed | The source upload was unsuccessful. | Correct the upload problem and retry upload. |
| Processing failed | Processing failed after the upload succeeded. | Read the explanation and use Retry Processing if available. |
While the library is open, displayed assets that are still progressing receive status updates approximately every two seconds. Updates stop for completed or failed assets and when the library closes.
The current processor verifies and copies the uploaded bytes unchanged. It does not repair geometry, convert file formats, add textures, or normalize model units. A ready status does not guarantee that malformed OBJ contents can be rendered.
Correct model size or orientation
Choose Edit on an uploaded asset to change its metadata. Supported source units are millimetres, centimetres, metres, inches, and feet; the default is metres. Corrective rotations are quarter turns: 0, 90, 180, or 270 degrees around each axis.
Use source units when the model has the wrong overall scale because of its export units. Use corrective rotations when its source axes make it appear sideways or upside down.
These corrections belong to the shared asset and affect its uses across scenes. Read the confirmation before saving. Per-placement transforms remain separate. Other sessions observe metadata changes after refreshing and resolving the asset again.
Delete an uploaded asset
Choose Delete beside the asset and review the confirmation. This removes the asset from the organization’s library, affecting all scenes that reference it. Existing scene references remain but may display a missing-model representation.
To remove only one occurrence from your plan, delete the selected model placement instead.